The main variables of this function are set and defined in program O9750 as

shown below.

Variable	setting	description
#101	200	First probe touch feedrate
#102	3	Tool offset type. (1=A，2=B，3=C)，default=1
#103	1	Single-sided measurement setting
#104	2	Probe orientation
#105	0.3	Back-off distance. default=0.3
#106	0	Two tool setting probes (0=NO,1=YES)
#109	1	Tool offset register type (1 = Radius, 2 = Diameter). Default=1
#110	10	Tool diameters larger than this size rotate. (Tool Length measuree)
#111	100	Tool diameters larger than this size are measured single-sided
#113	100	Initial approach clearance point above the stylus.
#114	10	Secondary approach clearance point above the stylus.
#117	5	Default overtravel distance(*1). default=5
#118	0	OTS probe (yes=1,NO=0)
#120	520	The base number for #500 series calibration data. default=520
#121	1	Multi-axis option only: Machine X axis.
#122	2	Multi-axis option only: Machine Y axis.
#123	3	Multi-axis option only: Machine Z axis.
#124	2000	‘Long tool/Short tool’ search feedrate. Default=2000
#125	5	Radial clearance(*2). Default=5
#127	5000	Rapid traverse feedrate. Default=5000
#128	1	Language: 1=English, 2=German, 3=French, 4=Italian
#138	200	Long tool value.
#139	30	Short tool value.
#145	0.005	In-position zone(*3), Defult=0.005

Note: *1: Overtravel is the distance towards the stylus that the tool is permitted to move before a

PROBE FAIL alarm is initiated.

*2: Radial clearance is the distance between the tool and the stylus when moving

down the side of the stylus.

*3: used for checking whether the stylus is already triggered at the beginning of the measurement move. Typically this value does not require adjustment.

TS27R using Using Fanuc