Syntec CNCmon32 No link and solution.

The machine with a Syntec controller is relying on the network to project the information and data to the frontend IPC/PC screen and there are many important settings both on CNCmon32 package and network of PC need to be discreetly set and followed to ensure the logics of information transfer. Here under is a very common error that could be caused by the wrongdoing of machine operator. When operator had tried to open the CNCmon32 of front-end IPC prior to the Syntec controller ready for linkage, then a warning pop-up screen has been answered wrong which led to the CNCmon32 interface being switched to non-link mode.

Click on the link below to download the document.